Audiosoul and TONOR sell two quite different kinds of indoor acoustic treatment. Audiosoul’s original 52-pack of charcoal wedge foam panels is sold as fifty-two nominal 12 × 12 × 1-inch open-cell foam pieces. TONOR’s original ASIN describes four larger 47.2 × 23.6 × 0.72-inch self-adhesive polyester-fiber wall panels. One offers many small foam wedges; the other uses large decorative dual-layer strips. Neither is independently verified to block sound between rooms.
Source and image integrity: The old comparison displayed the TONOR image with an Audiosoul label and the Audiosoul image with a TONOR label. This revision uses their correct existing WordPress product-review assets, retains both original affiliate ASINs, and attributes the listed dimensions to ASIN-matched seller records rather than claiming firsthand measurement or laboratory tests.
First determine whether you need absorption or isolation
Soft porous acoustic treatment can help absorb room reflections, reducing some echo around speech, recording and listening positions. That is not the same as sound insulation through a door, ceiling or shared wall. Installation coverage, frequency, thickness, gaps, existing furnishings and panel placement all influence the result. One-inch foam wedges are not proof of effective bass control, and a dual-layer polyester décor panel does not become a high-mass sound barrier by being advertised as soundproof.
Audiosoul: fifty-two smaller wedge foam pieces

An ASIN-specific Audiosoul listing matches original B08QQRWDWS to a 52-piece charcoal acoustic wedge foam pack, with nominal 12 × 12-inch faces and 1-inch thickness. Its square-face dimensions would give 52 sq ft of rectangular front area when all 52 pieces are used, before allowing for cutouts, installation gaps or any retail dimension variation. This does not mean 52 sq ft of soundproof wall area or a certified absorption coefficient.
Audiosoul’s marketing focuses on reducing flutter echo and room reflections in small studios, home offices or vocal spaces. The wedges give a textured arrangement, but there is no independently measured same-frequency NRC or full spectral absorption curve for this exact ASIN in the sources reviewed. Broad phrases such as “studio grade,” “soundproofing” or “maximum absorption” should not be converted into guaranteed decibel improvements.
Small pieces can be grouped around primary reflection points or spaced in a pattern, but proper alignment matters. One-inch lightweight foam is not a substitute for deep bass treatment. Adhesive/mounting supplies are not confirmed for the selected current package, so check what is included and whether the surface finish allows safe placement. Read the published Audiosoul source review and inspect the original Audiosoul Amazon offer before buying.
TONOR: four much larger decorative wall panels

A TONOR original-ASIN specification identifies B0CX7VYD6T and model 24014 as four 47.2 × 23.6 × 0.72-inch large panels, described as 100% polyester fiber, with a self-adhesive dual-layer design. Multiplying the rectangular outer dimensions gives 4 × 47.2 × 23.6 ÷ 144 ≈ 30.94 sq ft of nominal front face. Another seller field quotes approximately 4,400 square inches or 30.56 sq ft; neither is independently measured installed treatment coverage.
The larger panels are marketed as both interior wall décor and echo treatment. Their “dual layer” wording concerns the panel construction; it does not demonstrate the same acoustics as a decoupled building wall or certify transmission loss. The advertised 0.72-inch thickness is smaller than Audiosoul’s nominal 1 inch but cannot be directly converted to a frequency-response comparison because the core materials and constructions differ.
TONOR panels can create broad contiguous decorative coverage with only four pieces and fewer seams. They still require careful wall preparation and must not obstruct sockets, vents or heat sources. A product-specific fire report would be needed if used in a building with regulated surface-lining requirements. See the published TONOR source review and the unchanged TONOR Amazon offer.
Side-by-side product comparison
| Buyer question | Audiosoul wedges | TONOR dual-layer panels |
|---|---|---|
| Original ASIN | B08QQRWDWS | B0CX7VYD6T |
| Pack count | 52 small pieces | 4 large pieces |
| Nominal piece dimensions | 12 × 12 × 1 in | 47.2 × 23.6 × 0.72 in |
| Material type | Acoustic wedge foam, seller-described | Polyester fiber dual-layer panel |
| Total rectangular outer-face area | 52 sq ft | About 30.94 sq ft |
| Mounting approach | Separate individual foam pieces; verify adhesive | Self-adhesive large panels |
| Independent same-method absorption/fire test | Not established | Not established |
Audiosoul’s package has more nominal front-face area, but the pieces are smaller, different materials are involved, and neither has a matched lab comparison. A 52-versus-31-square-foot calculation is not an acoustic performance rating. In a home studio, placement at specific reflection points may matter more than buying the pack with the largest headline surface area.
How to choose
Consider Audiosoul when many small panels and a classic wedge aesthetic suit a studio corner or speech setup. Consider TONOR when a simpler large-panel decorative wall is desirable and polyester-fiber panels are appropriate to the room. Neither should be selected to stop airborne noise from neighbors without separately assessing partition structure, leaks and flanking paths.
Installation checks
- Confirm the selected ASIN, package count, color and piece size.
- Identify the actual reflection problem and layout before applying adhesive.
- Use compatible mounting methods and test paint and wall finish first.
- Allow for outlets, ventilation, maintenance access and emergency devices.
- Do not infer fire certification from retail “flame resistant” text alone.
- Do not promise a tested decrease in sound transfer through a wall.
FAQs
Does more Audiosoul foam area mean greater soundproofing?
No. The numerical face area is not a tested wall-isolation figure, and panel placement/material properties differ.
Is TONOR made from polyurethane acoustic foam?
The matched seller specifies polyester fiber for its dual-layer panel; it should not be assumed to be the same construction as wedge foam.
Can either replace bass traps?
No reliable evidence indicates that these thin packages provide the same low-frequency control as appropriately designed deeper treatment.
Were the two images switched in the old article?
Yes. This version uses the correct product-owned photos and makes their identities explicit.
SPD’s decision
Both are plausible room-reflection treatments for different layouts. Audiosoul provides many small wedge pieces; TONOR provides four large decorative polyester panels. Choose by the intended room treatment rather than unsupported decibel claims.
Affiliate disclosure: Both original Amazon product links are affiliate links. As an Amazon Associate I earn from qualifying purchases.
Good luck and happy soundproofing!