Affiliate disclosure: This article contains affiliate links. We may earn a commission if you purchase through them, at no additional cost to you.
As an Amazon Associate I earn from qualifying purchases.
SPD’s take: RecPro’s metallic bubble insulation belongs first in the thermal and vapor-management conversation. It may have a supporting role in an RV noise-control build, but a thin, lightweight reflective layer is not a proven substitute for a vibration damper, a dense sound barrier or a properly designed insulated wall. We would not buy it solely on the strength of an advertised “sound baffling” claim.
Identify the exact roll before comparing prices
The RecPro product family offers 48-inch and 72-inch widths and selectable lengths including 15 feet. This review focuses on the originally advertised 72-inch-wide × 15-foot configuration at nominal 3/16-inch thickness. Six feet by 15 feet gives 90 sq ft of theoretical face coverage, before overlaps, cuts and installation waste. It has a polyethylene closed-cell reinforced bubble core and metallic reflective facings according to RecPro.
Retail identity caution: this older SPD article uses Amazon ASIN B07MFM3S7B. We could confirm that RecPro offers the relevant product family and dimension options, but could not independently verify that the original ASIN currently selects the exact 72-inch × 15-foot variant. Check the Amazon seller’s width, length and SKU rather than treating the link as a guaranteed match.
What RecPro’s “97% radiant heat” statement means
RecPro advertises “blocks 97% radiant heat.” That is a manufacturer thermal-radiation claim, not evidence of 97% less engine noise, 97% less sound transmission, or a complete installed assembly’s R-value. Real thermal performance depends on the entire assembly, including air gaps and installation conditions. The maker also markets the material as a vapor barrier and describes sound baffling/road-noise reduction without publishing a complete assembly sound-isolation rating for this specific roll.
Where it fits in an RV sound-control system

Think about the source first. Panel rattles need damping; whistles and drafts need sealing; voices and passing traffic call for an appropriate full sound-isolation assembly. Reflective bubble material primarily makes sense when its thermal and moisture-control properties match the RV envelope design. It can be only one part of a much larger job.
For broader material selection, see SPD’s RV soundproofing material guide. It separates vibration, insulation, barriers and sealing rather than treating every product marked “soundproof” as interchangeable.
Practical checks before installation
- Moisture and condensation: verify where an impermeable layer belongs in the particular wall/roof assembly; trapped moisture can promote mold or hidden corrosion.
- Vehicle systems: keep drains, ventilation, access panels, sensors, electrical connections and service points accessible.
- Fire and heat: check the actual rating required by the RV maker and local rules. A heat-reflective marketing claim does not establish fire approval or suitability near exhausts, wiring faults or open flames.
- Joining and fastening: the effectiveness of a vapor-control layer depends on joints, penetrations and the specified installation method, not just the roll material.
- Budget: calculate based on measured net surface and waste rather than using the advertised roll area as finished coverage.
Should it be selected for road-noise reduction?
We would consider it where a properly planned RV thermal assembly already needs a reflective bubble component. If the principal complaint is tire roar or floor-panel resonance, start with the noise path and the proper damping/isolating materials instead. The original RecPro-linked Amazon listing requires a fresh size/variant check; the exact ASIN-to-manufacturer SKU mapping remains unconfirmed.
Source: RecPro official Metallic Bubble Multi-Use RV Insulation listing and variant selector. Claims are identified as manufacturer claims; SPD has not independently measured radiant heat, thermal resistance or airborne sound transmission for this configuration.
Good luck and happy soundproofing!