Siless Liner vs Noico Red: Foil Foam or PE Sheets?

Siless Liner 157 mil and Noico Red 150 mil are both self-adhesive closed-cell polyethylene foam liners for automotive interior insulation, but Siless adds an aluminum foil-facing surface. Both original ASINs are associated with 36 sq ft nominal packages. Their advertised thicknesses—157 mil (~4 mm) and 150 mil (~4 mm)—are close, so the foil finish, sheet or roll format, thermal application limits and actual available clearance matter more than choosing a winner from the seven-mil label difference.

Evidence and media scope: We checked Siless’s own product page, Noico’s original-ASIN listing, both published SPD source posts, the original tracked affiliate ASINs and pre-existing media. The site-owned Siless Liner image is attached to the appropriate parent review but its WordPress media-library title incorrectly identifies a Siless Black 80 mil butyl mat. That metadata is not repaired in this comparison and the photo is not offered as proof of a material test.

A foam liner is not a constrained-layer butyl mat

Both products are positioned primarily as interior foam layers that can help with thermal conditions and decouple touching surfaces. They are different from heavy adhesive butyl/foil mats designed for damping the resonance of bare metal panels. A foam layer may complement a suitable damping mat in a broader installation, but neither foam should be presented as an independently certified sound barrier that blocks all road noise. Correct surface contact and safe clearance remain essential.

Siless Liner 157 mil: foil-faced PE foam in a roll

Existing image attached to SPD Siless Liner 157 mil closed-cell foil-faced foam review; source media title incorrectly identifies a different Siless mat
Existing image attached to the Siless Liner review; its media-library title is mislabeled as Siless Black 80 mil. Exact source asset identification remains a media-metadata exception.

Siless’s product page identifies 157 mil / about 4 mm closed-cell polyethylene foam with an aluminum foil finish, marketed in a 36 sq ft self-adhesive roll. A corresponding ASIN-matched regional specification associates original B085642G7M with model SLF36, nominal dimensions of approximately 8.4 meters long × 0.4 meters wide and a 36 sq ft coverage label. The geometric roll dimensions total 3.36 m², or about 36.17 sq ft, agreeing with the rounded advertised figure.

The foil surface can influence radiant heat exchange within an appropriately designed construction, but whether a meaningful radiant barrier exists depends on the assembly and adjacent air space, not simply on the shiny material. Siless advertises that its product blocks “98% of radiant heat,” but this statement is not independently established for a specific installed car cavity in the evidence available here. It is therefore not a measured advantage over Noico Red in this comparison.

A long adhesive roll may be convenient for larger relatively continuous areas, but the installer must measure, trim, account for folds and observe any service components. The adhesive backing and foil should not be assumed safe for direct high-heat exhaust, catalyst or engine-adjacent use without product-specific approval. For additional information see the published SPD Siless Liner review and verify the original Siless Liner Amazon selection.

Noico Red 150 mil: precut closed-cell PE sheets

Existing SPD Noico Red 150 mil 36 square foot closed-cell automotive foam liner review image
Correct site-owned Noico Red source-review image for its original 34-piece foam liner package.

An original-ASIN-matched Noico product record describes B07TKXMPH7 as 150 mil / around 4 mm closed-cell PE foam with self-adhesive backing, in 34 individual sheets nominally 15.7 × 9.8 inches, marketed as 36 sq ft. The geometric total is 34 × 15.7 × 9.8 ÷ 144 ≈ 36.32 sq ft. Unlike Siless’s named foil laminate, the matched Noico specification lists a PE foam liner; any highly reflective metal film should not be silently inferred from a brand name or from the word “liner.”

A source-based Noico technical description lists an operating limit up to approximately 190°F / 88°C and explicitly warns not to use this foam as a high-temperature shield for mufflers, catalytic converters or particulate filters. A foam layer that can be used behind appropriate interior trim is not a substitute for a purpose-rated exhaust heat barrier, and no article should recommend layering this product on a high-temperature metal location solely because it has a thermal-marketing claim.

With smaller sheets, Noico may be easier to arrange across discrete sections or narrow contours, although seams may require more careful planning. Check the selected pack, adhesive behavior and actual thickness before use. Read the published Noico source review and the retained Noico Red Amazon link.

What is independently supported?

Factor Siless Liner 157 mil Noico Red 150 mil
Original ASIN B085642G7M B07TKXMPH7
Material core Closed-cell PE foam Closed-cell PE foam
Facing Aluminum foil-faced laminate PE foam liner; no separately verified foil facing
Nominal thickness 157 mil / approximately 4 mm 150 mil / approximately 4 mm
Advertised area 36 sq ft 36 sq ft
Product format One adhesive roll, approximately 8.4 × 0.4 m 34 adhesive sheets, about 15.7 × 9.8 in
Relevant safety detail Do not infer hot exhaust compatibility from foil Specified warning against high-heat exhaust use
Independent same-vehicle heat/acoustic result Not established Not established

A seven-mil marketing thickness difference is about 0.178 mm; manufacturer rounded descriptions call both products 4 mm. That does not translate to a known thermal resistance or acoustic difference. Both manufacturers advertise 36 sq ft; the minor geometric variation comes from rounded original dimensions rather than proof one product has more useful installed material.

How to decide

Consider Siless if a foil-faced long roll is specifically compatible with the intended interior assembly and an appropriate radiant-heat design exists. Consider Noico Red if the job favors a large number of ready-sized PE foam sheets and a clear published high-temperature warning. Neither should be used as a standalone remedy for hollow-door noise leaks, loose trim clips or vibrating bare metal without diagnosing those different sound paths.

Installation and safety guidance

  • Verify the exact 36 sq ft original ASIN and material construction for both products.
  • Measure actual safe-access panels and available clearance behind trim.
  • Clean and dry surfaces, check compatible adhesive temperatures and test a short piece first.
  • Keep vents, water drains, airbags, seatbelts, wiring and access panels unobstructed.
  • Do not place generic foam liners next to mufflers, catalytic converters or direct engine exhaust.
  • Inspect finished bonding and mechanical clearance before using the vehicle.

Frequently asked questions

Is 157 mil meaningfully thicker than 150 mil?

Nominally by 7 mil, or about 0.178 mm; both products are marketed as approximately 4 mm. Actual installed behavior is not determined by that number alone.

Does Siless’s aluminum face prove its “98% radiant heat” claim?

No. A specific installed assembly and reproducible measurement would be needed to validate the asserted performance.

Is Noico Red a butyl vibration-damping mat?

No. Its original linked product is a closed-cell polyethylene foam lining material.

What is wrong with the Siless review image metadata?

Its existing media-library title names a different Siless Black 80 mil product, even though the asset is attached to the Siless Liner source review. That record should be reconciled separately.

SPD’s decision

Both are 36 sq ft PE foam insulation options with different surfaces and formats. Siless supplies the foil-faced roll; Noico supplies separate red foam sheets with an explicit heat-exposure warning. Choose by actual assembly, verified seller identity and fit, not a seven-mil numerical difference or untested heat claims.

Affiliate disclosure: The original two Amazon links are affiliate links. As an Amazon Associate I earn from qualifying purchases.

Good luck and happy soundproofing!