X AUTOHAUX 10 mm Hood Mat: 2.16 Sq Ft Fit and Heat Checks

Affiliate disclosure: This article contains affiliate links. We may earn a commission if you purchase through them, at no additional cost to you.

Key distinction: The X AUTOHAUX 394-mil (10 mm) foil-faced sheet is a small insulation accessory—not an entire engine-hood liner or a verified cure for road noise. This original linked variant is advertised as a 19.69 × 15.75-inch piece, useful only if its material and adhesive are approved for the intended temperature and location.

Editorial evidence: Seller and brand product references, not an SPD thermal, flammability or vibration test. As an Amazon Associate I earn from qualifying purchases.

Measure the actual sheet before choosing it

An X AUTOHAUX product listing at Harfington describes a 394-mil (10 mm) product in a 19.69 × 15.75-inch format with advertised coverage of about 2.16 square feet. Calculation: 19.69 × 15.75 ÷ 144 = approximately 2.15 square feet. That slight difference is rounding; it is not evidence of an extra usable cut piece.

The brand offers many other 10 mm sheets and rolls with different dimensions. Do not apply the coverage of a 39-inch sheet to this linked SKU. If your project requires more than one small panel, use a paper pattern of the accessible surface, estimate cutting waste, and verify package count rather than assuming one order covers an entire hood or boat engine cover.

What this layered material is intended to do

Listings describe a reflective aluminum-foil-facing layer over foam-like insulation. The facing and core may form part of a specified thermal or vibration treatment, but foil appearance alone does not establish an engine-safe service temperature or fire rating. Likewise, a foam or fibrous insulation layer is not interchangeable with a butyl constrained-layer damper or continuous heavy transmission barrier.

Even a physically compatible 10 mm pad can block drainage, impede clips or contact a moving component if installed blindly. The correct application depends on actual substrate, temperature, glue and vehicle or vessel service guidance. We did not verify a product-specific laboratory report for this exact retail variation.

Hood and marine use require more than a generic heat claim

Proposed location What must be checked
Car hood underside Factory liner/attachment design, hood closing clearance, hot parts, fire and adhesive rating
Fender cavity Water drainage, road spray, movement and corrosion exposure
Boat engine cover Marine fire, heat, fuel-vapor, ventilation and vibration requirements specific to that installation
Cooler interior panel Whether the correct insulation layer, surface and available 10 mm clearance are confirmed

Do not install generic foam near exhaust parts, catalytic converters, electrical terminals, fuel systems or required service openings. For hood projects, review the vehicle manufacturer’s liner specifications first. SPD’s engine-bay sound-deadening guide explains why safety and material choice cannot be separated.

How it compares with larger 10 mm kits

Our X AUTOHAUX versus Storystore comparison addresses the much larger Storystore sheet. Our X AUTOHAUX versus AggSound comparison covers a different seller/package decision. This article remains the standalone small-sheet sizing and installation-fit assessment.

Purchase decision: Only consider this small-format sheet where product documentation confirms safe substrate, fire/temperature and adhesion conditions. Do not rely on generic “hood soundproofing” claims. Check the exact size, material construction and quantity on the original tracked X AUTOHAUX listing. Current stock and seller-selected variation remain unverified.

Good luck and happy soundproofing!